Motorcycle clutch kits come with Kevlar friction plates and a starburst groove pattern for maximum heat dissipation and oil circulation. A result of years of development and testing these V Twin motorcycle clutch kits offer superior performance to get the power to the ground. All of the clutch plates are manufactured from high tempered American steel and each kit comes complete with a pre-set clutch pack height (stock spec) for easy installation.
1998 & LATER BIG TWIN AND TWIN CAM KIT CONSISTS OF 9 FRICTION PLATES AND 8 STEELS
This kit does not include a diaphragm spring. Plates should be pre-soaked in the same fluid you will be using in the bike for about 10-15 minutes prior to installation. The type of fluids we recommend are Most Primary Lubricants or any HD petroleum based, non-synthetic, primary oil, as light weight as possible. THE USE OF SYNTHETICS IS NOT RECOMMENDED AS THEY TEND TO CAUSE SLIPPAGE. Start with a friction plate and end with a friction plate. The OEM clutch will have 1 odd friction plate that will have a larger inside diameter to accommodate a judder spring and seat that will fit inside that 1 odd plate. Remove all those pieces and do NOT reuse them with this kit. This means all friction and steel plates. You must use everything in this new replacement kit. This kit has a premeasured stack height so everything must be used. Do NOT mix the old and new plates together. These are just some helpful tips. For further technical assistance refer to your service manual